sticky-icky-icky-ooh-wee

sticky-icky-icky-ooh-wee

Presenting…the new way of attaching a Joint/Pre-roll/Vape cartridge to your fntsma greeting cards!

side note- Shooooooooot. I think its genius but I’m kind of embarrassed to be so proud of it…kind of…It’s so simple and obvious.

Now you can attach a Joint/Pre-roll/Vape cartridge anywhere on the card, and you could probably use it to attach an edible or a gift card from your local dispensary. The new fastener will roll out starting Jan 2021. As with all the products that are added to the shop, your feedback makes these products better and I welcome all feedback on these fasteners when they begin to roll out.

fntsma_fstener_display.jpg
fntsma_fstener_display2.jpg

 

 

 

 

 

 

 

 

 

 

 

some details below:

The fastener

  • The fastener is approximately 2.75” x .5”

  • Two(2) fasteners will be included per card

  • side 1 is branded with the fntsma logo

  • side 2 is divided in three sections “peel - do not peel - peel“

  

To fasten your Joint/Pre-roll/Vape cartridge

  1. remove both “peel” sections - you can remove the middle “do not peel” section for more support but not recommended when used in direct contact with the joint/pre-roll paper.

  2. stick one side down on the card

  3. place the joint/pre-roll in the middle and sort of stretch and stick the other side down on the card

 

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.